Canna Flush

Canna Flush is a cleaning product that removes excess nutrients from plants and substrates. Extra nutrients can negatively impact subsequent growth cycles due to over-fertilisation or malnutrition, leaving a bitter metallic taste in your crops.

Flushing is the process of replacing your nutrient solution, which contains water and food for your plant, with plain water. This process will vastly improve your harvest’s flavour, aroma, and quality.

Canna Flush, used with short growing cycle plants, helps reduce the nutrients left in the crop to speed up the finishing stage.

This cleaning product offers the following features and characteristics:

• Unwanted nutrients are flushed out
• Crops taste better
• Prevents over-feeding
• Cleans all growing media
• Good bacteria or fungi are unaffected

How does it Work?

Growers can use Flush to clean all substrates without killing beneficial bacteria or fungi. During the final week of the blooming phase, plants begin to swell and no longer take up large amounts of nutrients; they sometimes release excess nutrients back into the solution. Replacing the nutrient solution with plain water will encourage absorption and nutrient release.

You can monitor the conductivity level of the flush water in the reservoir using a conductivity meter. As the plant returns nutrients into the water, the levels increase.

Hydroponic growers living in areas with hard water should see better results by allowing the plant to fully mature and then flush for another week. Replacing the reservoir water with fresh water mixed with this product may be necessary several times.

How to Use?

Use Flush just before harvest to ensure your plant removes all excess nutrients. Cleaning with this product will provide a clean and tasty harvest.

Nutrient problems can arise for many reasons; flush for 24 hours, refresh the nutrient solution, and remove excess. This process enables the plant to remove unwanted nutrients.

24-hour Flush Checklist:

• Remove your nutrient solution from its reservoir and clean the container and pipe system.
• Flush the system with water to remove unwanted elements (i.e. Salts).
• Refill your reservoir with plain water or Canna Flush solution.
• Test the pH levels and correct them if required.
• Let the water or solution circulate for 24 hours and then remove it from the reservoir.
• Replace with fresh nutrient solution.

Harvest Flush Checklist:

• Check the conductivity levels during the last 2 to 3 weeks of the harvest to gradually reduce the nutrient strength.
• Remove the nutrient solution from the reservoir one week before harvest and replace it with plain water or Canna Flush.
• Test the pH level and correct it as necessary.
• Leave the solution to circulate until harvest time.

How do I buy Canna Flush?

You can easily buy Canna Flush from our website.